The
1-3/8" Low Peak 4-Way Canopy Fitting - Slope is designed to be used to form the middle sections of the peak of a low gable sloped roof (lean-to) canopy frame. The angle of the corner angle along the eave
formed by this fitting is 102 degrees (rise angle of 12 degrees). At this angle, the canopy rafters will rise at a rate of 2.5" / linear foot. These fittings are primarily used to create a sloped roof,
lean-to canopy structure along side an existing building or canopy frame. Our canopy fittings are crafted from 16 gauge galvanized steel with fully welded corners and
connections. Make sure to check out our entire line of
Low Peak Canopy Fittings .
Application
Forms the middle sections of the peak of a low gable sloped roof (lean-to) canopy frame.
Low Peak Angle
The angle of the corner angle along the eave formed by this fitting is 102 degrees (rise angle of 12 degrees)
Galvanized steel construction to resist rusting
Designed for use with 1-5/16" outer diameter pipe
Outer Diameter (OD): 1-1/2"
Inner Diameter (ID): 1-3/8"
Leg Length: 4-3/8"
Peak Angle: 78º
Eave Angle: 102º
Thickness: 16 gauge
